Teledyne 6712FR Installation And Operation Manual page 78

6712FR Refrigerated Sampler
Section 4 Standard Programming
Table 4-3 Reports: Program Events, Source Codes, and Error Codes (Continued)
(The Source and Error Codes Listed below refer to why a sample was taken and what happened while it was being
taken.)
*C Calibrate sample
*D Disable
*E Enable
Ev Event
*F Flow
*G Grab sample
M Command driven sample A command driven sample.
PH Phone command
R Resume
*S Start
Sw Switch time
TO Time Override
*T time
*DJ Distributor Jammed
*IP sample in progress
*L pump latch open
*ND no distributor arm
*NL No Liquid Detected
LF Not enough flow
*NM No More Liquid
M Bottle Full
*O Sampler Shut Off
Ov Probable Overflow
*P Power Failed
*PJ Pump Jammed
*Sk Sample Skipped
*US User Stopped
4-22
Source Codes
Sample volume delivered during calibration.
Sample event at disable time.
Sample event at enable time.
Event-paced sample event.
Flow-paced sample event.
Sample volume delivered as a grab sample.
Phone command sample.
Sample event at resume time.
Sample event at start time.
Sample event at switch time.
Sample event at bottle-switch time.
Time-paced sample event.
Error Codes
The distributor jammed.
Sample in progress when report was printing.
Unable to take sample because the pump band was opened.
There is no distributor arm or the stop is damaged.
The sampler was unable to detect liquid.
Not enough flow for the minimum sample volume entered for samples with volumes
proportional to flow.
After the sampler detected liquid and while the sample was being taken, the liquid
detector stopped detecting liquid.
The composite bottle is full.
The sampler was turned off with the On-Off key during the sample event.
The sampler was directed to take a sample that would not fit into the bottle. Occurs
for flow paced, time override programs only.
The power supply failed during the sample event. Note: Power failures during five
consecutive sample events results in a LOW BATTERY shut-down.
The pump jammed.
Sample not taken.
You pressed the Stop key during the sample event.
Figures 4-5, 4-6, 4-7, 4-8, and 4-9 show examples of reports con-
figured to show program settings, sampling results, combined
results, and a summary report.