Attaching A Uhf Portable Tuner; Microphone System) - Sony HDW F900R - CineAlta Camcorder - 1080p Operation Manual

Close the CAC-12.
Tighten the screw.
f
5
Set the LINE / AES/EBU / MIC switch to MIC.
Set the +48 V/OFF switch to +48 V if you use an
external power supply type microphone. Otherwise,
set the switch to OFF.
Connect the microphone cable to the AUDIO IN CH1
or AUDIO IN CH2 connector.
Note
When you detach the CAC-12 Microphone Holder once
you have attached it to the camcorder, be careful not to lose
the two screws fixing the CAC-12. After detaching the
CAC-12, be sure to put the two screws back into their
original places (see the figure illustrating the step 1
operation).
7-5-3 Attaching a UHF Portable
Tuner (for a UHF Wireless

Microphone System)

To use a Sony UHF wireless microphone system, attach
one of the following UHF portable tuners.
• WRR-855A/855B UHF Synthesized Tuner Unit
• WRR-861A/861B/862A/862B UHF Portable Tuner.
For each of these UHF portable tuners, use the following
attachment procedure.
For details, refer to the UHF portable tuner manual.
Fitting the WRR-855A/855B
You can use the WRR-855A/855B UHF Synthesized
Tuner Unit simply by inserting it into the slot in the
camcorder, and fastening the fixing screws.
1
ECM-678 or similar
microphone
2
WRR-855A/855B
For the operation of the WRR-855A/855B, refer to the
manual supplied with the WRR-855A/855B.
Fitting the WRR-861A/861B/862A/862B
(with a battery pack)
1
Undo the four fixing screws holding the cover of the
slot, and remove the cover.
Insert the WRR-855A/855B, and fasten the four fixing
screws.
Set the AUDIO IN CH-1/CH-2/CH-3/CH-4 switches for the
desired audio recording channel to WIRELESS or W.
(1) Attach the WRR tuner fitting (not supplied, service
part number: A-8278-057-A) to the back of the
camcorder.
1 Use a Phillips-type screwdriver to tighten the
four screws placed in the tuner fitting. For three
of these screws, insert the screwdriver through
the corresponding hole and tighten the screw.
2 Loosen the adjustment screws.
3 Adjust the tuner fitting position for a battery
pack to be attached, and tighten the adjustment
screws to fix its position.
4 Attach the mount plate supplied with the WRR-
861A/861B/862A/862B.
(2) Attach the battery pack.
123
Audio Input System