Using An Ac Adaptor; Using The Anton Bauer Ultralight System; Adjusting The Viewfinder; Adjusting The Viewfinder Position - Sony HDW F900R - CineAlta Camcorder - 1080p Operation Manual

When the external battery begins to fail and an
internal battery pack is not used
First load the camcorder with a fully charged internal
battery pack, then remove the DC output cable of the
external battery from the DC IN connector. The power
source will switch to the internal battery pack. To use an
external battery again, connect a fully charged external
battery to the DC IN connector before unloading the
internal battery pack. The power source will switch to the
external battery.
Continuous operation when operating with only
an internal battery pack
First, connect a fully charged external battery to the DC IN
connector, then change the internal battery.
Notes
• When an internal battery pack is loaded and an external
battery is connected to the DC IN connector, the external
battery is always used as the power source.
• There may be some noise on the video signal at the
instant the power sources are switched.

7-1-3 Using an AC Adaptor

Mount the AC-DN10 on the camcorder in the same way as
a battery pack, then connect to the AC power supply. The
AC-DN10 can supply up to 100 W of power.
7-1-4 Using the Anton Bauer
Ultralight System
By fitting the camcorder with the Anton Bauer Ultralight
system, and setting the LIGHT switch to AUTO, you can
switch the light on and off automatically as you start and
stop VTR operation. This system operates with lights
powered by 12 V, with a maximum power consumption of
50 W.
7-2 Adjusting the
Viewfinder
For maximum viewing convenience, you can adjust the
viewfinder position in the left-right and backward-forward
directions.

7-2-1 Adjusting the Viewfinder

Position
Adjusting the position to the right or left
1
Loosen the viewfinder left-right positioning ring.
2
Adjust the viewfinder to the most convenient position
for viewing by sliding it to the right or left.
3
Tighten the viewfinder left-right positioning ring.
To store the camcorder in the carrying case
Always store the camcorder with the viewfinder moved
to an AC power
fully in the direction opposite to the barrel and the
source
viewfinder left-right positioning ring tightened.
Adjusting the position backward or
forward
1
Loosen the viewfinder front-rear positioning lever and
the LOCK knob.
117
Adjusting the Viewfinder