Attaching A Uhf Portable Tuner (For A Uhf Wireless Microphone System) - Sony PXW-X320 Operating Instructions Manual

Notes
• If the input level on the camcorder is not at an
appropriate setting for the microphone sensitivity, loud
sounds may be distorted, and the signal-to-noise ratio
may be affected.
• In order for the AUDIO IN CH-1 and CH-2 connectors
on the camcorder to be able to provide a phantom 48 V
power supply, female XLR connectors (3-pin) are
fitted. If the microphone cable has a female connector,
use an adaptor.
• When you detach a CAC-12 Microphone Holder, be
sure to put the two screws back into their original
places.
Attaching a UHF Portable Tuner
(for a UHF Wireless Microphone
System)
To use a Sony UHF wireless microphone system,
power the camcorder off and then fit one of the
following UHF portable tuners.
• DWR-S02D Digital Wireless Receiver
• WRR-855S UHF Synthesized Tuner Unit
• WRR-860C/861/862 UHF Synthesized
Diversity Tuner
For details of these units, refer to the operation
manuals for them.
Note
The optional WRR Mount Bracket (service part number:
A-1999-908-B) is required to fit the WRR-862.
For details, contact a Sony sales or service
representative.
To fit the DWR-S02D or WRR-855S
1
Remove the four fixing screws holding
the cover of the portable tuner/receiver
housing slot located in the rear of the
camcorder, to remove the cover.
2
Insert the DWR-S02D or WRR-855S
into the housing slot, and fasten the four
fixing screws.
DWR-S02D or WRR-855S
3
Set the AUDIO IN selector for the
channel to which you want to input
audio signal to WIRELESS (see
page 17).
40