Fuji Electric FEH300b Hardware User Manual page 33

Dip switch number 2 (CF Card interface cover access control)
When the dip switch number 2 is set to the ON position, access to the CF card is possible
whether the cover is opened or not. In case access to the CF card is disabled because of
Caution
damage of the CF card interface cover, set the dip switch number 2 to the ON position.
Normally keep it in the OFF position.
With the dip switch number 2, the LED status when the CF card interface cover is opened can be set.
Dip switch number 2
OFF
ON
Dip switch number 3, 4 (Not used)
Set the dip switch number 3 and 4 to OFF.
Dip switch number 5, 6, 7, 8 (Terminating resistor setting)
When connecting a controller at CN1 via RS-232C, set the dip switch number 5 and 7 to the
Caution
OFF position.
• When connecting a controller at CN1 via RS-422/485 (2-wire connection), set the dip switch number 7 to the ON
position.
• When connecting a controller at CN1 via RS-422/485 (4-wire connection), set the dip switch number 5 and 7 to the
ON position.
• For the following connections at modular jack 1 or 2, set the dip switch number 6 or 8 to the ON position.
• Master station for multi-link 2 connection
• Connection with a controller (PLC, temperature controller, etc.) via RS-485
• Connection with the card recorder "CREC" (optional)
• Connection with the serial extension I/O "V-I/O" (optional)
• Connection to the @E.Terminal at the termination of V-Link connection via RS-485
* Detaching controller unit
To operate the dip switch in NP5M0101-5H4/4H4, NP5N0011-5H4/4H4, remove the controller unit.
Remove mounting screws at three places to remove the controller unit from the display unit.
Be careful not to drop or lose the mounting screws.
Mounting screws at three places
M3 screws thread,
Tightening torque:
0.5 to 0.7N·m
LED Contents
Access to the CF card is not performed.
Not lit
CF card can be removed.
Accessing the CF card.
Lights up in red
After the access is finished, the LED goes off.
Lights up in red Access to the CF card is possible at all times.
2-19
2-6 Dip Switches
CN7
CN5
SX-BUS ONL
ERR
UROM
IN RUN
ALM
BAT
4:RUN
3:U-TERM
2:TERM
1:STOP
CPU
No.
OUT
+
24V DC
-
FG
USER ROM CARD USB
LOADER
MJ2 CN1 LAN U-B U-A
MJ1
CF