Sd Vflash Card; Replacing The Sd Vflash Card - Dell PowerEdge M820 Owner's Manual
Dell poweredge m820 systems owner's manual
Hide thumbs
Also See for PowerEdge M820:
- Owner's manual (155 pages) ,
- Technical manual (47 pages) ,
- Reference manual (1682 pages)
Table of Contents
Advertisement
5.
Insert the new USB memory key into the USB connector.
6.
Close the blade.
7.
Install the blade in the enclosure.
8.
Enter the System Setup and verify that the USB key is detected by the system.
Figure 14. Replacing the USB Memory Key
1. USB memory key connector
2. USB memory key
SD vFlash Card
Replacing The SD vFlash Card
1.
Remove the blade from the enclosure.
2.
If installed, remove the SD vFlash card from the card slot.
NOTE: The SD vFlash card slot is located underneath LOM riser card 1 and can be identified by the SD vFlash card
slot identification label.
3.
To install the SD vFlash card, insert the contact-pin end of the SD card into the card slot on the vFlash media unit
with the card label side facing up.
NOTE: The slot is keyed to ensure correct insertion of the card.
4.
Press inward on the card to lock it into the slot.
5.
Install the blade in the enclosure.
41
Advertisement
Table of Contents
Troubleshooting
