Dell PowerEdge M820 Owner's Manual page 112

Error Code Message Information
PSU0002
Message
LCD Message Predictive failure on PSU <
Details
Action
PSU0003
Message
LCD Message Power input for PSU <
Details
Action
PSU0004
Message
LCD Message Power input for PSU <
Details
Action
PSU0005
Message The power input for power supply <
attached to the system.
Details The operating requirements for the power supply may be found in this manual or on the
power supply itself.
Action Verify the input power is within the operating requirements for the power supply.
PSU0006
Message
LCD Message
Details
Action
PSU0007
Message Power supply <
Details A power supply that is designed to operate at 220V, but is connected to a 110V power
source requires additional current for operation. The additional current may trip circuit-
breakers or cause other electrical issues with the input source.
Action Check input power source and cabling. Use recommended input power. Review this
Manual. If the issue persists, see
112
A predictive failure detected on power supply <
System performance and power redundancy may be degraded or lost.
Remove and reinstall the power supply at the next service window. If the issue persists,
see Getting Help.
The power input for power supply <
number > is lost. Check PSU cables.
The power supply is installed correctly but an input source is not connected or is not
functional.
Verify the input source is attached to the power supply. Verify the input power is within
the operating requirements for the power supply.
The power input for power supply <
number > is outside of range. Check PSU cables.
The operating requirements for the power supply may be found in this manual or on the
power supply itself.
Verify the input source is attached to the power supply. Verify the input power is within
the operating requirements for the power supply.
number > type mismatch.
Power supply <
number > is incorrectly configured. Check PSU.
Power supply <
Power supplies should be of the same input type and power rating.
Install matched power supplies and review proper configuration in this manual.
number > is operating at 110 volts, and could cause a circuit breaker fault.
number >.
number >. Check PSU.
number > is lost.
number > is outside of the allowable range.
number > is outside of the allowable range, but it is
Getting Help.