Figure 16. Removing and Installing a Processor/DIMM Blank
1. processor socket
2. processor/DIMM blank
3. tabs (4)
4. heat sink retention screws (4)
Installing A Processor/DIMM Blank
1.
Remove the blade from the enclosure.
2.
Open the blade.
3.
If installed, remove the processor and heat sink.
4.
Position the processor/DIMM blank on the system board with the holes on the tabs of the processor/DIMM blank
secured to the heat sink retention screws on the system board.
5.
Install the cooling shroud.
6.
Close the blade.
7.
Install the blade in the enclosure.
43