Installing Memory Modules - Dell PowerEdge M820 Owner's Manual

c) system board
5. If required, lift the latch on the mezzanine card support bracket to the open position.
6. Locate the memory module socket(s).
CAUTION: Handle each memory module only on either card edge, making sure not to touch the middle of the
memory module.
7. Press down and out on the ejectors on each end of the socket until the memory module pops out of the socket.
8. If applicable, install the following:
a) system board
b) mezzanine card(s)
c) SSD/hard-drive backplane(s)
9. If applicable, close the latch on the mezzanine card support bracket.
10. Install the cooling shroud.
11. Close the blade.
12. Install the blade in the enclosure.
Figure 22. Installing and Removing a Memory Module or Memory Module Blank
1. memory module or memory blank
2. edge connector
3. ejectors (2)
4. socket
5. alignment key

Installing Memory Modules

WARNING: The memory modules are hot to the touch for some time after the system has been powered down.
Allow time for the memory modules to cool before handling them. Handle the memory modules by the card edges
and avoid touching the components on the memory module.
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
59