Using The Remote Control; Inserting And Removing The Batteries; Setting Remote Control Numbers; Using The Remote Control As A Wired Remote Control - Panasonic PT-EX12KU Operating Instructions Manual

Using the remote control

Using the remote control

Inserting and removing the batteries

1) Open the cover.
(i)

Setting remote control numbers

When you are using multiple projectors, you can set a remote control number to each projector to allow
simultaneous control with a single remote control.
After setting a remote control number to the projector, specify the same remote control number to the remote
control.
■ Setting method ■
1) While holding the <MENU> button, press the number (<0> - <9>) buttons (2 digits) to
enter the desired remote control number.
■
z When you release your finger, the remote control number will change to the new number.
■
z To set the remote control number to 09, press <0>, <9> while holding down the <MENU> button.
Note
■
z The factory default setting is [All]. [All] supports all remote control numbers.
■
z Set the remote control number of the projector using [Remote control] (
■
z To reset the remote control number (to set to [All]), simultaneously hold down the <MENU> button and the
<0> button for at least five seconds.

Using the remote control as a wired remote control

Connect the <REMOTE IN> terminal on the projector body to the wired remote control terminal on the remote
control using the remote control cable (commercially available).
■
z Make sure that the batteries are inserted in the remote control.
■
z To use the remote control wirelessly, disconnect the remote control cable from the projector and the remote
control. When the remote control cable is connected, you cannot use the remote control wirelessly.
24 - ENGLISH
(ii)
2) Insert the batteries and close the
cover.
■
z Insert the side first.
■
z To remove the batteries, perform the above
procedure in the reverse order.
page 77) from the [Setting] menu.
