Powering On The Projector; Making Adjustments And Selections - Panasonic PT-EX12KU Operating Instructions Manual

Powering on the projector

Control panel
Power button
Before turning on the power, remove the lens cover.
1) Connect the power plug to the outlet.
(AC 100 V - 240 V 50 Hz/60 Hz)
2) Press the side of the main power
switch to turn on the power.
■
z After a moment, the standby indicator
<STANDBY> will go on and the projector will
enter the standby mode.
3) Press the power
control panel or the power <POWER
ON> button on the remote control.
■
z After a moment, an image will be projected
and the currently selected input signal and
lamp status ( page 96) will be displayed for

approximately four seconds.
Note
■
z When [PIN code lock] (
[On] using [Security] in the [Setting] menu, enter
your PIN code.
■
z The projector will make a noise when the lamp
comes on, but this is not a malfunction.
■
z During projection, the fan rotates, making a sound.
The sound may change depending on the ambient
temperature, and when the lamp is on, the sound
may become loud.
■
z If the lamp is switched off and immediately on
again, the newly projected image may wobble
for a few moments. This is due to the lamp
characteristics and is not a malfunction.
■
z When [Direct on] ( page 78) of the [Setting] menu

is set to [On], the power will be turned on as soon
as you insert the power plug into the outlet or set
the main power switch to the
■
z When [Display] ( page 69) of the [Setting] menu

is set to [On] and [Logo] (
the countdown will be displayed but the opening
display will not be displayed.
■
z When [Display] ( page 69) of the [Setting] menu is

set to [Off] or [Countdown off], projection will start
as soon as the lamp comes on, regardless of [Logo
select] ( page 76) setting.

Remote control
Power <POWER
ON> button
button on the
page 79) has been set to

side.
page 76) is set to [Off],

■
z After turning on the power, notes on [Filter warning]
and [Lamp replacement] may be displayed
depending on the status of the projector. (
Making adjustments and
selections
It is recommended that the images are projected
continuously for at least 30 minutes before the focus
is adjusted.
4) Press the <FOCUS> button to adjust
the focus of the image roughly.
( page 46)

5) Press the <INPUT 1> to <INPUT 4>
buttons on the remote control or the
<INPUT> button on the control panel
to select the input terminal. (
6) Adjust the projection angle. (
■
z Extend the adjustable feet to adjust the
projection angle.
7) Press the <LENS SHIFT> button to
adjust the position of the image.
( page 45)

8) Press the <ZOOM> button to adjust
the size of the image to fit the screen.
( page 46)

9) Press the <FOCUS> button again to
adjust the focus.
10) Press the <ZOOM> button again to
adjust the zoom and the size of the
image to fit the screen.
Powering on/off
page 97)

page 47)

page 35)

ENGLISH - 43