■ [Filter counter timer]
■
Sets a time to display a notification that the filter
has reached the end of its replacement cycle.
1) Select [Filter counter timer], and press
the <ENTER> button.
2) Press ▲▼ to switch the setting.
[Off]
[12000 H]
[8000 H]
[6000 H]
Note
■
z When [Off] is selected, blockages are detected
automatically.
■
z When the set time is exceeded,
■ [Filter counter reset]
■
Resets the value of [Filter counter].
After replacing the filter, be sure to reset the
counter.
1) Select [Filter counter reset], and press
the <ENTER> button.
■
z A screen for confirming whether to reset is
displayed.
2) Select [Yes], and press the <ENTER>
button.
■
z The confirmation screen is displayed.
3) Select [Yes], and press the <ENTER>
button.
Note
■
z Reset only after replacing the filter.
■
z When reset, the display of [Filter warning]
disappears.
[P-timer]
1) Press ▲▼ to select [P-timer].
2) Press the <ENTER> button.
■
z The sub menu 2 is displayed.
3) Press ▲▼ to select.
■ [Count up]
■
Elapsed time is counted from 00 min 00 sec.
Elapsed time from 00 min 00 sec to 180 min 00
sec is displayed.
■ [Count down]
■
Elapsed time is counted down from the set time.
Set the time using [Timer].
■ [Timer]
■
[1000 H]
Sets the [Count down] time.
[2000 H]
1) Select [Timer], and press the <ENTER>
button.
[3000 H]
2) Press ▲▼ to select.
[4000 H]
Note
■
z The factory default setting is "10 minutes".
■
z When [Count up] is selected, this item is grayed out
and cannot be selected.
■ [Start]
■
is displayed.
Starts the count-up or countdown.
1) Select [Start], and press the <ENTER>
button.
z The menu screen is cleared and the timer is
■ [Stop]
■
Pauses the count-up or countdown.
1) Select [Stop], and press the <ENTER>
button.
z The stopped state of the timer is displayed for
[Setting] menu
■
displayed.
■
approximately three seconds, then the display
returns to the menu screen.
ENGLISH - 83