Adjusting The Focus - Panasonic PT-EX12KU Operating Instructions Manual

Attaching the lens

Adjusting the focus

After setting up the projector, turn on the power, and then project the image on the screen. Adjust the position of
the projector and the projected image.
■ ET-ELW03 ■
1) Loosen the focus lock screw.
2) Rotate the lens to obtain the proper
focus on the center area of the screen.
■
z When the distance between the projector and
the screen is 1 m (39"), set the position of the
focus lock screw to the ● mark (yellow allow) of
the lens.
3) Tighten the focus lock screw.
4) If the proper focus is not observed
on outer area of the screen, proceed
further adjustment.
(i) Turn the focus ring counterclockwise to
loosen.
(ii) Rotate the lens to obtain the proper focus on
outer area of the screen.
(iii) Turn the focus ring clockwise to tighten.
•■If the proper focus is not observed over the
entire screen, repeat steps from the first.
mark
30 - ENGLISH
Focus ring
Focus lock screw
■ ET-ELT03 ■
1) Rotate (i) to adjust the zoom.
2) Rotate (ii) to obtain the proper focus
on the center area of the screen.
(i)
(ii)