Attaching The Lens - Panasonic PT-EX12KU Operating Instructions Manual

Attaching the lens

Attaching the lens
Attention
■
z The attachment procedure and parts vary depending on the optional lens. Check the product No. and attach
the lens properly.
■
z When using ET-ELW02, ET-ELS02, ET-ELS03, ET-ELT02, or ET-ELM01, tie up the cables using the cable
ties supplied with the projector before attaching the lens. If you attach the lens without tying up the cables, the
cables may contact the internal parts, causing malfunctions.
1) Install the lens attachment to the lens.
(i) Remove the lens covers on the front and rear
of the lens, install the lens attachment, and
secure with four screws supplied with the lens.
Focus lock screw
Screwdriver supplied
with the lens
Locate the motor on the right side.
(ii) Connect the lens motor lead connector to the
socket on the top right of the lens attachment
(the motor driven lens only).
Lens attachment
Lens motor lead
26 - ENGLISH
Lens attachment
Socket
Connector
2) Set the projector to the standby mode,
press the side of the main power
switch to turn off the power, and then
unplug the power cord from the outlet.
3) Turn the lens hood counterclockwise
to remove.
Lens hood
4) Remove two screws A, loosen
two screws B, and slide the lens
attachment cover forward to take off.
Lens attachment cover
5) Remove the cover plate.
Cover plate