Connections
Connections
Before connecting to the projector
■
z Read carefully the instruction manual of the device you intend to connect.
■
z Turn off the power switch of the device before connecting the cable.
■
z If a connection cable is not supplied with the device and the optional cable is not available, prepare a
connection cable to suit the device.
■
z Video signals containing too much jitter may cause the images on the screen to randomly wobble. In this case,
a time base corrector (TBC) must be connected.
■
z The projector accepts the following signals: video signals, S-video signals, analog RGB signals (synchronous
signals are TTL level), and digital signals.
■
z Some computer models are not compatible with the projector.
■
z When connecting a device to the projector using a long cable, it may not be possible to achieve a normal
picture without a compensator.
■
z For details of the video signals supported by the projector, refer to "List of compatible signals" (
Connecting example: Computers
Note
■
z Use an HDMI High Speed cable that adheres to the HDMI standard. Use of a cable that does not adhere to the
standard may result in abnormal operation such as cut-out of the image, failure to project, etc.
■
z The <HDMI IN> terminal can be connected with an external device with a DVI terminal using an HDMI/DVI
conversion cable. With some devices, however, normal operation may not be possible and images may not
appear. (
page 76)
■
z When the <DIGITAL IN> terminal is used, normal operation may not be possible with some devices and images
may not appear.
■
z The <DIGITAL IN> terminal (in the digital signal input mode) is compatible only with single link signals.
■
z For details of RGB signals from computers that the projector supports, refer to "List of compatible signals"
(
page 111).
■
z If you operate the projector using the computer with the resume feature (last memory), it may be required to
reset the resume feature.
■
z The <DIGITAL IN> terminal (in the digital signal input mode) may require the EDID setting depending on the
connected device.
■
z To connect the projector with a computer over a wired LAN, refer to the "Operating Instructions – Network
Operations" on the supplied CD-ROM.
36 - ENGLISH
page 111).