Table of Contents
Advertisement
TeamPoS 3000 XL and XL
8. Replace the back of the monitor. The stand needs to be perpendicular to the monitor to
do this. The back of the monitor must be replaced before replacing any of the other
cosmetic covers. Replace circular filler, rotating it until it is flush with the stand.
9. With stand facing away from you ease hinge cap into position over the hinge until it
snaps in place. Make sure that the tabs on each side ease into the notches.
10. Dispersed stands can be secured to the surface using brackets that come with the stand.
This will prevent them sliding during operation. A template showing the placement of
the brackets follows at the end of this section.
D900000145
2
Issue 3
Installation
5-51
Hide quick links:
Advertisement
Table of Contents
