Combo Board - Fujitsu TeamPoS 3000 XL Installation & Maintenance Manual

TeamPoS 3000 XL and XL

7.9.3 Combo Board

Combo cards provide support for both USB and legacy devices. The Combo card can be used by
itself or with the COM card in the XL model only. It contains six +12V powered USB ports, a
DB9 - RS232 port (COM 4), and a DB15 connector for a +24V powered printer (COM 3).
Caution: Be sure to observe all ESD precautions and power off procedures.
The first diagram below shows a XL Motherboard with the Combo Board and a COM Board
installed beneath it. The Combo Board can be installed by itself or with the COM card.
Caution: Ports designated as Port C on the backplane (24V PUSB) and Port 3
on the Combo board (24V RS232) do not meet UL limited power source (LPS)
requirements. These ports are limited to only allowing 24V Retail POS RS232
or powered USB peripherals that do not exceed a rated current of 4 Amps.
Peripherals intended to be connected via - Jacketed Cable for external use rated
30 V, max 3.05m long, marked VW-1 or FT-1.
Note: When the Combo Board is installed, only one 24V port should be used for 24V
printer. Port 3 and Port C cannot provide 24V power to 2 printers simultaneously.
D900000145
2
Issue 3
Maintenance
7-35