Usb Configuration Setup -Motherboard; On Chip Ide Device Setup -Motherboard - Fujitsu TeamPoS 3000 XL Installation & Maintenance Manual

TeamPos 3000 XL and XL
9.1.9 USB Configuration Setup - Motherboard
Factory Default Settings
NEC USB Configuration:
None
ICH4 USB Configuration:
USB Beep Message
Emulation Type
Device List Ex:
    : Move
Enter : Select
F5: Previous Values
9.1.10 OnChip IDE Device Setup - Motherboard
Factory Default Settings
 IDE Channel Master
 IDE Channel Slave
On-Chip Channel PCI IDE
IDE Channel Master PIO
IDE Channel Slave PIO
IDE Channel Master UDMA
IDE Channel Slave UDMA
IDE DMA transfer access
IDE HDD Block Mode
HDD S.M.A.R.T. Capability
Hard Disk Write Protect
ATA(P1) 80 Pin Cable
    : Move
Enter : Select
F5: Previous Values
D900000145
2
Phoenix – AwardBIOS CMOS Setup Utility
USB Configuration
[Disabled]
[Auto]
+/-/PU/PD : Value
F7: Optimized Defaults
Phoenix – AwardBIOS CMOS Setup Utility
OnChip IDE Device
[CD-224E-N]
[ None]
[Enabled]
[Auto]
[Auto]
[Auto]
[Auto]
[Enabled]
[Enabled]
[Disabled]
[Disabled]
Detection
+/-/PU/PD : Value
F7: Optimized Defaults
Issue 3
BIOS XL Motherboard
Item Help
Menu Level 
Information or instructions
will appear here for each
selection.
F10 : Save ESC : Exit
Item Help
Menu Level 
Information or instructions
will appear here for each
selection.
F10 : Save ESC : Exit
F1: General Help
F1: General Help
9-9