Single Dispersed Lcd Stand - Fujitsu TeamPoS 3000 XL Installation & Maintenance Manual

TeamPoS 3000 XL and XL

5.14.2 Single Dispersed LCD Stand

1. Remove only the hinge cap from the stand; leave the top and bottom hinge cover in place.
Some photos in this section show the bottom hinge cover and top hinge cover removed in
order to more clearly show the cable route; however, assembly is easier if the bottom
hinge cover and top hinge cover are left in place.
2. Remove the cover plate on the bottom of stand by removing the 4 M3x 05 flathead,
phillips 6mmcountersunk screws. Retain screws to reattach the cover plate after cables
have been routed.
D900000145
2
Issue 3
Installation
Hinge Cap
Lower Hinge
Cover
Top Hinge
Cover
5-46