Bios Setup Procedures Xl Motherboard; Opening Cmos Setup Screen; Cmos Settings - Fujitsu TeamPoS 3000 XL Installation & Maintenance Manual

TeamPoS 3000 XL and XL
Chapter 10. BIOS Setup Procedures – XL
If a motherboard is replaced in the field, it may be necessary to change the date and time
and setup the BIOS for the customer's configuration. The following information shows
the default screens from the factory.

10.1. Opening CMOS Setup Screen

Turn ON power and press the "F2" key while the terminal goes through the power on self
test (POST).
10.1.1.

CMOS Settings

If this is a new motherboard it will be necessary to set the date and time before releasing
the terminal to the customer. To change the date and time from the BIOS screen,
manually input the current date and time.
"SAVE & EXIT SETUP." Changing other default settings may be done at this time if the
customer has settings other than the default settings listed here. Changing settings that
are not the default or not set for specific customer needs may adversely effect the
operation of the unit.
In most cases, the CMOS default settings are adequate and do not require changing.
Follow the instructions on the screen to select STANDARD CMOS SETUP.
D900000145
2
Issue 3
BIOS XL
2
Motherboard
Run "LOAD SETUP DEFAULTS" then
2
Motherboard
10-1