Fujitsu TeamPoS 3000 XL Installation & Maintenance Manual page 101

TeamPoS 3000 XL and XL
6. Place the first LCD face down on a clean dry surface. Remove the back cover by
pressing in where indicated by symbol. Note the screws required to attach the LCD are
taped to the inside of this cover.
Back of LCD
Press Here and Lift
7. Attach (lightly) the operator facing arm of the stand to the back of the LCD with the
screws provided pushing the LCD as far towards the connectors as it will go. Make sure
that the tabs on the bottom hinge cover of the stand fit into the slots in the back of the
LCD. Finish tightening the screws so they are snug.
8. Place the customer facing LCD flat
D900000145
2
A to B USB for opt.
MSR or Keypad MSR
DVI
Notches for lower hinge cover
Issue 3
Back Cover
Mounting Screws
Panhead, Phillips
M3x0.5 x 8mm
LCD Power for opt.
Audio
power brick
pUSB
Installation
Touch Panel 1-2
Switch
VGA
5-55