Level Machine, Final Installation Check List - Fisher & Paykel Dryer Installation Instructions Manual

Final Installation Check List
Check that:
• No plastic or flexible metal foil is used in the exhaust ducting.
• Exhaust is rigid ducting or thick wall flexible metal ducting.
• All joints in the ducting are made with duct tape. It must not be connected with screws or other
fastening devices which extend into the inside of the duct.
• Ducting is clear] and is connected to the dryer.
• Dryer is level.
Additionally for Electric Dryer Models Only, Check:
• Dryer is plugged or directly wired into an approved fitting and is properly grounded.
• Dryer starts, heats, cools and shuts off
Additionally for Gas Dryer Models Only, Check:
• Dryer is plugged into an approved fitting and is properly grounded.
• All fittings in the gas line are tested for leaks.
• Exhaust temperature increases,to confirm ignition has occurred.
- If ignition does not occur initially, it may be due to air in the gas line or low voltage power supply.
- The gas regulator valve may fail to open if the power supply falls below 105Volts.