Table of Contents
Advertisement
2. Have a minimum clearance on all sides of at least 20mm.
3. Install the machine on a stable and level floor (if not stacking on top of a front loading washer).
• Do not install your dryer in such a way that the dryer door cannot be opened fully.
• Do not install the dryer outside, in a damp place, where there is a risk of freezing, where it may be rained on, in
direct sunlight or close to a source of heat.
• Do not place your machine on top of its power cable.
Levelling the Machine
It is IMPORTANT to level the machine to ensure the machine runs efficiently with minimal noise. The dryer should be
levelled in as close to its final position as possible so it stands balanced evenly on all four feet. Ensure the dryer does
not rock in any direction.
The dryer comes with four adjustable feet. Wind all four feet up or down
until the dryer is correctly level. A spirit level can assist with this process.
The machine is considered level when the bubble sits in the centre (ie
within the two lines or the circle), when the spirit level is placed flat on top
of your dryer, in the directions from:
1. left to right
2. back to front, and
3. corner to corner.
Never unscrew the feet completely from their housings.
After levelling, the corners of the dryer cabinet should be clear of the floor and the machine must not
rock in any direction.
Draining
The dryer is equipped with a condenser unit which accumulates water during the drying cycle. This water is collected in
the removable water tank located at the top left of the dryer. The accumulated water must be emptied after each drying
cycle. However you can also set up your dryer to drain automatically using the drain hose provided.
https://producthelp.fisherpaykel.com/au/Dry/Dryers/Heat_Pump/DH8060C1/User_Guide_DH8060C1/03_Installation_Instructio...
Levelling the feet
Updated: Sun, 25 Jun 2023 12:59:32 GMT
Powered by
3
Advertisement
Table of Contents
