Leveling The Machine - Fisher & Paykel DH8060P1 Installation Instructions Manual

1. Move the machine into the desired position. Do not lift the dryer by the top panel.
2. Have a minimum clearance on all sides of at least 20 mm.
3. Install the machine on a stable and level floor (if not stacking on top of a front loading washer).
• Do not install your dryer in such a way that the dryer door cannot be opened fully.
• Do not install the dryer outside, in a damp place, where there is a risk of freezing, where it may be rained on, in
direct sunlight or close to a source of heat.
• Do not place your machine on top of its power cable.

Leveling the machine

It is IMPORTANT to level the machine to ensure the machine runs efficiently with minimal noise. The dryer should be
leveled in as close to its final position as possible so it stands balanced evenly on all four feet. Ensure the dryer does not
rock in any direction.
The dryer comes with four adjustable feet, wind all four feet up or down until the
dryer is correctly level. A spirit level can assist with this process. The machine is
considered level when the bubble sits in the center (ie within the two lines or the
circle), when the spirit level is placed flat on top of your dryer, in the directions
from:
1. left to right,
2. back to front and
3. corner to corner
Never unscrew the feet completely from their
housings.
After leveling, the corners of the dryer cabinet should be clear of the floor and the machine
must not rock in any direction.
https://producthelp.fisherpaykel.com/nz/Dry/Dryers/Heat_Pump/DH8060P1/User_Guide_DH8060P1/03_Installation_instructions
Leveling the feet
Updated: Sat, 10 Dec 2022 09:57:54 GMT
Powered by
3