Trouble Shooting - Fisher & Paykel Dryer Installation Instructions Manual

Trouble Shooting
If there is a problem with your appliance, please check the following points before contacting
your local Fisher& PaykelAppliances Authorized Service Centre Dealer or Customer CareCentre.
Dryer Doesn't
Sta rt
Make sure the dryer plug is pushed
Dryer Doesn't
Heat
Dryer Shakes or
Makes Excessive
Noise
Greasy Spots on
Clothes
Lint on Clothes
Fuseis blown/circuit breaker is
tripped
Check the house fuse/circuit breaker
box and replace fuse or reset breaker.
Note: Most electric dryers use two
breakers.
Fuseis blown/circuit breaker is Check the house fuse/circuit breaker
_tripped, the dryer may tumble box and replace fuse or reset breaker.
but not heat
Gas service is off Make sure gas shutoffat dryer and main
shutoff are fully open.
Some shaking/noise is normal. Move the dryer to a flat place or] the
Dryer may be sitting unevenly floor, or adjust feet as necessary until
ever].
Improper use of fabric softener Follow directions or] fabric softener
package.
_Drying dirty items with clear] Use your dryer to dry only clear] items.
ones Dirty items carl stair] clear] items and
the dryer.
Clothes were not completely Sometimes stains which cannot be seer]
clear] when the clothes are wet"appear"after
drying. Use proper washing procedures
before drying.
Lint filter is full Clear] lint screen before each load.
Improper sorting Sort lint producers (like chenille) from
Static Occurs
Static electricity carl attract lint See suggestions in this section under
STATIC.
Overloading Separate large loads into smaller ones.
Paper,tissue, etc. left in pockets Empty all pockets before laundering
clothes.
Overdrying Try a fabric softener.
: Synthetics, permanent press
and blends carl cause static.
Try a fabric softener.
44