Fisher & Paykel Dryer Installation Instructions Manual page 37

Using Your Dryer
7. Beginning Drying Cycle
Once you have chosen all your desired settings, close the dryer door and press START(located or]
the right hand side of the control panel).
Opening the door during the operation will stop the dryer.
To restart the dryer, close the door and select STARTto complete the cycle.
8. Stopping Your Dryer
Your dryer carl be stopped during any stage of the drying process,to allow you to check or] your
load or add/remove clothes.
To do this, open the dryer door. There will be a slight delay asthe drum slows down and stops.
Note:
If the cycle is interrupted before it progresses into COOL DOWN, parts of the drum may be hot.
To start your dryer again, press START.
9. Changing Cycles During Operation
If you wish to change the drying cycle you have chosen after the machine has already begun
drying, press your new cycle selection or] the control panek
10. Fabric Softener Sheets
If you want to use fabric softener sheets, you must ensure that they are labelled "dryer safe".
Always follow the instructions or] the packaging. Do not place them in a dryer with warm clothes
as there is a chance the fabric softener may stair] clothes. Only use a softener sheet once, then
discard it.
11. Beeps
At the end of the cycle, the dryer will beep to let you know that the load is finished. The drum
will automatically come to rest, allowing you to open the door and remove your load.
37