Exhaust Venting - Fisher & Paykel Dryer Installation Instructions Manual

Exhaust Venting
Fire Hazard
Use metal exhaust duct°
Do not use a plastic exhaust duct°
Do not use thin metal Dil exhaust ducto
Failuireto do so can iresult in death oirfire°
1 Read the exhaust section (pages ] 3 - 18) before installing the exhaust system to determine the
maximum allowable exhaust duct length.
Do not use sheet metal screws when assembling ducting. Always use suitable duct tape. Never
use plastic or thin metal foil flexible exhaust material.
2 The exhaust outlet is located close to the center of the rear of the dryer. Make sure you join the
exhaust duct to the dryer with duct tape only. This will prevent lint and dust from escaping from
the dryer and exhaust system.
!
@ Exhaust outlet
298mm (11 3/4")
3 The exhaust vent car] be routed up, down, left, right or straight out the back of the dryer. Referto
diagram.
19