Fisher & Paykel Dryer Installation Instructions Manual page 18

Alternative Exhaust Directions
Adding Elbow and Duct for Exhaust to Right or Left Side of Cabinet
m Preassemble ]OOmm (4") elbow with ]OOmm
(4") duct. Wrap duct tape around joint.
m Insert duct assembly, elbow frst, through the
side opening and connect the elbow to the
dryer internal duct.
Be sure not to pu[[ or damage the electrical
wires inside the dryer when inserting the duct°
• Apply duct tape as shown or] thejoint between
the dryer internal duct and the elbow.
Exhaust can _,__s_i_]4J
beaddedtoj _)_'_" ___--"_j
leftor rightside _______
_"-..,_ .-" Duct tape
.. j"
Internal duct joints must be secured with tape,
otherwise they may separate and cause a safety
hazard.
Duct tape
Adding Elbow for Exhaust through Bottom of Cabinet
• Insert the elbow through the rearopening and connect it
to the dryer internal duct.
• Apply duct tape or] the joint between the dryer internal
duct and elbow, as shown above.
Internal duct joints must be secured with tape,
otherwise they may separate and causea safety
hazard.
Adding Cover Plate to Rear of Cabinet (Sides and Bottom Exhaust)
• Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate (kit
WE1M454) available from your local service provider. Place
dryer in final location.
Plate (kit WE1 M454)