Exhaust Venting - Fisher & Paykel Smartload DEGX1 Installation Instructions And User Manual

Exhaust Venting

Read the exhaust section (page 14 – 18) before installing the exhaust system to determine the
1
maximum allowable exhaust duct length.
Do not use sheet metal screws when assembling ducting. Always use suitable duct tape.
Never use plastic or thin metal foil flexible exhaust material.
The exhaust outlet is located close to the center of the rear of the dryer. Make sure you join the
2
exhaust duct to the dryer with duct tape only. This will prevent lint and dust from escaping from
the dryer and exhaust system.
13 7⁄8" (352mm)
The exhaust vent can be routed up, down, left, right or straight out the back of the dryer.
3
Refer to diagram.
WARNING
Use heavy metal exhaust duct.
Do not use a plastic exhaust duct.
Do not use thin metal foil exhaust duct.
Failure to do so can result in death or fire.
Exhaust outlet
13 1⁄8" (333mm)
Fire Hazard
Does not include
foot height
US
CA
19