Exhaust Venting - Fisher & Paykel DE60FA2 Installation Instructions And User Manual

Exhaust Venting

1 Read the exhaust section (pages 13 – 18) before installing the exhaust system to determine the
maximum allowable exhaust duct length.
Do not use sheet metal screws when assembling ducting. Always use suitable duct tape. Never
use plastic or thin metal foil flexible exhaust material.
2 The exhaust outlet is located close to the center of the rear of the dryer. Make sure you join the
exhaust duct to the dryer with duct tape only. This will prevent lint and dust from escaping from
the dryer and exhaust system.
298mm (11 /")
3 The exhaust vent can be routed up, down, left, right or straight out the back of the dryer. Refer to
diagram.
WARNING
Use metal exhaust duct.
Do not use a plastic exhaust duct.
Do not use thin metal foil exhaust duct.
Failure to do so can result in death or fire.
Exhaust outlet
Fire Hazard
US
CA
19