Hard Disk Drive - Lenovo ThinkServer RS110 Type 6435 Hardware Maintenance Manual

10. Turn on all attached devices and the server.
11. See the documentation that comes with the Remote Supervisor Adapter II

Hard disk drive

Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this section.
Attention:
server cover is in place and fully closed whenever you install or remove a hard disk
drive.
Note: If a RAID controller or adapter is installed, you might have to reconfigure the
disk arrays after you install or remove hard disk drives. See the documentation that
comes with the adapter for more information.
Removing a simple-swap Serial ATA hard disk drive
Attention:
power from the server before you remove or install a simple-swap hard disk drive.
To remove a simple-swap SATA drive from the bay, complete the following steps.
6. If the riser-card assembly is an optional PCI-X riser-card assembly, reconnect
the riser-card power cable to the riser-card assembly.
7. Install the cover (see "Installing the cover" on page 61).
8. Slide the server into the rack.
9. Connect the cables and power cords.
SlimLine for information about installing the firmware and configuring the
adapter. If you have a backup copy of the configuration, restore the
configuration.
To avoid damage to the hard disk drive connectors, make sure that the
Simple-swap hard disk drives are not hot-swappable. Disconnect all
Chapter 4. Removing and replacing server components
69