Lenovo ThinkServer RS110 Type 6435 Hardware Maintenance Manual page 88

Hard disk
drive assembly
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the server cover is in place and fully closed.
3. Turn off the server and peripheral devices, and disconnect the power cord and
4. Remove the filler panel from the bay.
5. Pull the loops of the drive tray toward each other and pull the tray out of the
Installing a simple-swap Serial ATA hard disk drive
Attention:
power from the server before you remove or install a simple-swap hard disk drive.
To install a simple-swap Serial ATA hard disk drive, complete the following steps.
Note: If you have only one hard disk drive, install it in the left drive bay.
Hard disk
drive assembly
Attention:
server cover is in place and fully closed whenever you install or remove a hard disk
drive.
70
ThinkServer RS110 Types 6435, 6436, 6437 and 6438: Hardware Maintenance Manual
on page 57.
all external cables.
bay.
Simple-swap hard disk drives are not hot-swappable. Disconnect all
To avoid damage to the hard disk drive connectors, make sure that the
SATA hard disk
drive back plate
Filler panel
SATA hard disk
drive back plate
Filler panel