Installing A Remote Supervisor Adapter Ii Slimline - Lenovo ThinkServer RS110 Type 6435 Hardware Maintenance Manual

3. If the riser-card assembly is an optional PCI-X riser-card assembly, disconnect
4. Grasp the riser-card assembly at the front and rear edges and lift to remove it
5. Spread the mounting bracket retention latches as you lift the Remote Supervisor

Installing a Remote Supervisor Adapter II SlimLine

See the illustration in "System-board optional device connectors" on page 11 for the
location of the dedicated connector for the Remote Supervisor Adapter II SlimLine.
After the Remote Supervisor Adapter II SlimLine is installed, the
systems-management port on the rear of the server is active.
the riser-card power cable from the riser-card assembly.
from the server. Set the riser-card assembly aside on a flat, static-protective
surface.
Mounting bracket
retention latch
Mounting bracket
Adapter II SlimLine, to disconnect it from the system board; then, lift it out of the
server.
Note: You can press the middle of the mounting bracket toward the back of the
server to spread the retention latches.
Remote Supervisor Adapter II SlimLine
Chapter 4. Removing and replacing server components
Mounting bracket
67