Lenovo ThinkServer RS110 Type 6435 Hardware Maintenance Manual page 197

Table 13. Diagnostic messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
v See Chapter 3, "Parts listing, RS110 Types 6435, 6436, 6437 and 6438 server," on page 27 to determine which
components are customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained
service technician.
Message
number Component
201-802-xxx Memory
Test State
Memory Test Aborted
Description Action
Test canceled: the
1. Turn off and restart the system.
end address in
2. Run the test again.
the E820 function
is less than 16 3. Make sure that all DIMMs are enabled
MB. in the Configuration/Setup Utility
program (press F1 at system startup).
4. Make sure that the BIOS code is at the
latest level. The installed firmware level
is shown in the Diagnostic event log in
the Firmware/VPD section for this
component. For the latest level of
firmware, start firmware, go to
EasyUpdate or go to:
http://www.lenovo.com/support/ and
select your system to display a matrix
of available firmware.
5. Run the test again.
6. If the problem remains, collect the data
from the Diagnostic event log and send
it to Lenovo Service. For information
about contacting Lenovo Service, see
http://www.lenovo.com/support/.
179
Chapter 5. Diagnostics