1. To install the left bezel, if you removed it, insert the tab at the right end of the
2. Make sure that all internal cables are correctly routed.
3. Set the cover on top of the server so that approximately 13 mm (0.5 inch)
4. Slide the cover forward and into position.
5. Slide the server into the rack.
Removing an adapter
To remove an adapter, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
62
ThinkServer RS110 Types 6435, 6436, 6437 and 6438: Hardware Maintenance Manual
Release
latch
bezel into the front of the chassis and pivot the bezel until it snaps into place.
extends from the rear.
on page 57.