Lenovo ThinkServer RS110 Type 6435 Hardware Maintenance Manual page 86

Notes:
1. When you start the server for the first time after you install a Remote Supervisor
2. Earlier versions of the Remote Supervisor Adapter II SlimLine might not work in
To install a Remote Supervisor Adapter II SlimLine, complete the following steps.
68
ThinkServer RS110 Types 6435, 6436, 6437 and 6438: Hardware Maintenance Manual
Adapter II SlimLine, the startup process will take several minutes longer than a
typical startup.
this server. See http://www.lenovo.com/accessories for the supported Remote
Supervisor Adapter II SlimLine versions.
1
Remote Supervisor Adapter II
SlimLine
2
Mounting bracket
1. Put the protective plastic cover on the Remote Supervisor Adapter II SlimLine.
2. Turn the Remote Supervisor Adapter II SlimLine so that the keys on the
connector align correctly with the connector on the system board.
3. At a downward angle, insert the free end of the adapter under the tab on the
mounting bracket, aligning the holes in the adapter with the posts on the
mounting bracket. Rotate the front end of the adapter into the front mounting
bracket, aligning the holes in the adapter with the posts on the front mounting
bracket.
4. Press the Remote Supervisor Adapter II SlimLine firmly into the connector and
make sure that all tabs on both mounting brackets secure the adapter in place.
Attention: Incomplete insertion might cause damage to the server or the
adapter.
5. Carefully align the riser-card assembly with the guides on the rear of the
server and with the riser-card connectors on the system board; then, press
down on the assembly. Make sure that the riser-card assembly is fully seated
in the riser-card connectors on the system board.
3
Mounting bracket
4
Mounting bracket retention latch