Area Check; External Tracing; Automatic Hoop Movement In Area - Brother BES-1241BC Instruction Manual
Nine needle four head electronic embroidery machine; twelve needle four head electronic embroidery machine
Hide thumbs
Also See for BES-1241BC:
- Parts manual (143 pages) ,
- Instruction manual (16 pages) ,
- Maintenance manual (14 pages)
Table of Contents
Advertisement
Chapter 6 Operation of Machine
6. Area Check
6-1 External Tracing
6-2 Automatic Hoop Movement in Area
0.1mm
Embroidering area
Note) After finishing the movement inside the area by this function, execute external tracing. Then, check that
the needle and the presser foot do not interfere with the hoop before starting embroidering.
Embroidering area
If the pattern is not held in the embroidering area as shown below, the hoop cannot move into the area.
Enlarge the embroidering area on the operation panel.
130
Embroidering
start position
(Example)
0.1mm
BES-941BC • BES-1241BC
• If the check switch is pressed in other
cases than "area over", the rectangular
outline of the pattern is traced.
Note) The outline of pattern can be checked in rect-
angle or octagon by setting "Checking em-
broidery area" in "Enviromment 1".
• If "area over" is displayed, press the check
switch. The hoop automatically moves
inside the embroidering area, where the
pattern is set, at the nearest position.
- Quick Links:
- Electrical Section
Hide quick links:
Advertisement
Table of Contents
