Area Check; External Tracing; Automatic Hoop Movement In Area - Brother BES-1240BC Instruction Manual
Nine needle four head electronic embroidery machine; twelve needle four head electronic embroidery machine
Hide thumbs
Also See for BES-1240BC:
- Parts manual (143 pages) ,
- Maintenance manual (14 pages) ,
- Referencia de máquina (14 pages)
Table of Contents
Advertisement
7. Area Check
7-1 External Tracing
7-2 Automatic Hoop Movement in Area
0.1mm
Embroidering area
• If "area over" is displayed, press the check switch. The hoop automatically moves inside the
embroidering area, where the pattern is set, at the nearest position.
Note) After finishing the movement inside the area by this function, execute external tracing. Then, check that
the needle and the presser foot do not interfere with the hoop before starting embroidering.
Embroidering area
If the pattern is not held in the embroidering area as shown below, the hoop cannot move into the area.
Enlarge the embroidering area on the personal computer.
Embroidering
start position
(Example)
0.1mm
BES-940BC • BES-1240BC
• If the check switch is pressed in other
cases than "area over", the rectangular
outline of the pattern is traced.
Chapter 7 Operation of Machine
199
Hide quick links:
Advertisement
Table of Contents
