Brother BES-1241BC Instruction Manual page 56

Chapter 2 Embroidering Procedures
54
THREAD SENSOR lamp
When red light is on, thread breakage sensor is functioning. When the light is off,
the sensor is not effective. When the embroidery machine stops due to thread
breakage, the lamp flashes.
HEAD switch
When it is set to ON, needle bar on the head moves for embroidering. When it is
set to OFF, the needle bar does not move for embroidering.
MENDING lamp
This lamp lights up when the embroidery machine is in the mending mode.
A lamp on the head with an error lights up. (only when the error can be located)
MENDING switch
This switch is set to upside to drive or to suspend the machine head for a
designated period of time when the machine steps back during embroidering.
STEP BACK/FWD switch
When it is turned to BACK, the machine steps back. When it is turned to FWD,
the machine steps forward. If you keep the switch turned for a while, the machine
will continue stepping even after you let the switch alone. When it is turned to the
opposite side, the machine stops.
During timing adjustment of the rotary hook in the test mode, the rotary hook
slightly rotates to the left/right when this switch is turned to left/right respectively.
Refer to "Adjustment of Timing Between Needle and Rotary Hook" (
further details.
If any error occurs, it can be reset.
BES-941BC • BES-1241BC
page 154) for