Brother BES-1241BC Instruction Manual page 159

e
w
* Bad example
t
r
• The thread trimmer connecting rod B q
has a backlash of about 0.1 ~ 0.2 mm back
and forth. Tighten the two bolts e while
q
pulling them forward by the backlash
amount.
• Tighten the two bolts e so that the thread
trimmer connecting rods B q and C w
are positioned in a straight line.
Toward
this side
5. After adjustment is finished, reset the stop
switch.
"Release stop SW to operate!" disappears.
6. Turn the power switch off once, then on
again. Check that the clearance between
the movable knife r and the fixed knife t
is 1 mm.
7. When adjusting again, follow the step 2 and
after.
1mm
BES-941BC • BES-1241BC
Chapter 8 Standard Adjustment
157