Brother BES-1241BC Instruction Manual page 54
Nine needle four head electronic embroidery machine; twelve needle four head electronic embroidery machine
Hide thumbs
Also See for BES-1241BC:
- Parts manual (143 pages) ,
- Instruction manual (16 pages) ,
- Maintenance manual (14 pages)
Table of Contents
Advertisement
Chapter 2 Embroidering Procedures
Operation panel
52
FLAT
CAP
HOOP
Selects the flat or cap hoop. This selection should be done before turning the power ON
to the machine. The setting will not be changed if the selection is done after turning the
power OFF.
Moves the hoop.
Step-back or forward is available during suspension. (Use
Changes the speed range during embroidering (Use
Carries out inching of the hoop when the switch is pressed in the inching mode.
Move the cursor for selecting sewing data and an icon.
Moves the needle bar. The needle moves by the diameter every time this switch is pressed.
Change to the screen for selecting sewing data.
BES-941BC • BES-1241BC
Contrast volume
Adjusts the screen contrast.
SBUS interface connector
Not used (Do not connects anything.)
RS-232C interface connector
Connect personal computer with BE-100 installed, etc.
switches only.)
switches only).
- Quick Links:
- Electrical Section
Hide quick links:
Advertisement
Table of Contents
