Chapter 6 Operation of Machine
1. Operating Procedures
1-1 Power Source
Emergency stop switch
1-2 Preparation for Embroidering
• Select embroidering data.
• Using the jog switches (
Note) An error message is displayed on the LCD if a pattern comes out of the hoop.
• Pressing
starts embroidering.
• After embroidering is finished, the machine is placed in the stand-by state.
124
1. Turn the power on to the machine.
2. Reset the emergency stop button.
3. Press the power switch.
4. A message is displayed on the LCD.
• The alarm sounds three times and the
Power switch
), determine a position to start embroidering.
BES-941BC • BES-1241BC
needle bar and the presser foot move
upward. Then the hoop moves to the zero
point and the sewing data screen is
displayed.
Note) When turning the power off and back it on
again, wait for at least 10 seconds.