Table of Contents
Advertisement
To install bagger components
to tractor
1
1.
Discharge Chute
2
2.
3/8 Nut
3.
Flat Washer
3
Remove discharge chute from rear of tractor. Unhook the
two (2) straps and pull chute out and away from tractor.
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
1. 3/8 Lock nut
2.
Flat Washer
3.
Support Tube
1
1. Support Bracket
5
2.
Clevis Pin 10 x 17mm
3.
3/8 Lock Nut
4.
3/8 x 63,5mm Hex Bolt
5.
lO,3mm (13/32") flat washer
6.
Retainer Spring
•
install the two upper support brackets through the back
plate and to the chassis, install the clevis pin 10x17mm
and secure with retainer spring.
•
Assemble
both support brackets to the outside of the
bagger support tube using two each 3/8 x 63,5mm hex
bolts13/32" I.D. flat washers and 3/8 Iocknuts from parts
bag. Tighten securely.
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
1.
Hook
2.
Discharge Chute
3.
Back plate slot
3
•
Replace
discharge chute into rear opening
of tractor.
Secure the chute with the two hook straps.
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the discharge chute to float with the
mower deck when moving on uneven terrain.
24
Advertisement
Table of Contents
