Table of Contents
Advertisement
3. Click on the Port Map Enable radio button to activate port mapping for the
4. Click OK. Port mapping for the selected port will now be enabled or disabled
Enabling and Disabling Link Traps
Link traps are generated to management stations in the MicroMMAC-T's Trap
Table when stations insert into the ring (i.e., the port status on the MicroMMAC-T
changes from ENB to INS) or remove themselves from the ring (i.e., the port
status changes from INS to ENB). By default, these traps are disabled at a station
to reduce the amount of management traffic on your network. You can use
NetSight Element Manager to enable these traps for a selected station, so that you
can more fully view its network activity.
The Link Trap window
traps for the selected port, and allows you to either enable or disable link traps for
the port.
To enable or disable link traps for a selected port:
1. Click on the desired Port index on a module display in the Chassis View
2. Click on Link Trap.... The Link Trap window,
Managing the Hub
Figure 2-15. The Port Map Window
port, or the Port Map Disable radio button to turn off port mapping.
as desired.
(Figure
window. The Port pull-down menu will appear.
The MicroMMAC-T Chassis View
2-16) allows you to view the current state of link
Figure
2-16, will appear.
2-29
Advertisement
Table of Contents
