Maintenance; Beveling; Replacing Cutter Blades - Craftsman 113.206891 Owner's Manual

BEVELING
Adjust the fence to the desired angle.., tighten fence and
guard lock knobs,
For pieces of wood 3" or wider hold the board firmty down
on both tables and firmly against the fence (as i!lustrated)
with your hands on the side and top of the workpiece,..
keep fingers close together.
NOTE: Removing only the corner on the edge of a board is
known as CHAMFERING while beveling is removing the
corner or the edge of the board down to the boards
surface.
Normally a chamfer is made with one cut.,, therefore, a
cut deeper than 1/16 in. may be made,
For pieces of wood less than 3" wide use hold down/push
blocks (as illustrated) on the side of the workpiece so you
can hold the workpiece in toward the fence at all times as
welt as down against the table top,
WARNING: DO NOT CONTACT THE CUTTING KNIVES
OR THE GUARD WITH THE PUSH BLOCKS,
BEVELING BOARD WIDER THAN 3 INCHES
CHAMFER BEVEL
BEVELING BOARD NARROWER THAN 3 INCHES
NOTE: Rabbeting on a Jointer is considered to be a
dangerous operation because it requires removal of the
cutter guard and increases the potential of kickback
because of excessive depth of cut.
NEVER ATTEMPT TO PERFORM A RABBETING OPERA-
TION ON THIS JOINTER, DO NOT OPERATE JOINTERi
PLANER WITH CUTTERHEAD OR BELT GUARDS
REMOVED.
Rabbet cuts should be made on the Radial Saw or Table
Saw by making two cuts with the sawblade or by using the
Dado Head or Molding Head, Rabbet cuts can also be
made using the Shaper or Portable Router.
maintenance
REPLACING CUTTER BLADES
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE ADJUSTING, MAINTAINING, OR
LUBRICATING YOUR JOINTER-PLANER.
1, Remove belt guard.
2. Position fence to right . . , approximately 1/4 in.
beyond cutter blades .... lock it in place,
3, Lower infeed table all the way down,
4, Place block of wood 6-3/4 in, long between cutter-
guard and fence.
,i ii i ii i llll illlllllllllllll
RABBET CUT
BLOCK OF WOOD
/
19