Craftsman 113.206891 Owner's Manual page 22

i i :
• • /_• !•: i/: ¸ _ : •
:2: Position guard as shown, wtthPIVOT PIN above hole
in infeed table: :
3. Align SLOT in pin with TANG in spring, and press
down, :
4. Replace cotter pin.
FENCE
IN PLACE
i
TANG OF SPRING
IN CENTER OF
HOLE
CUTTER
GUARD
_INFEED
TABLE
PIVOT PIN
_"""'_ TANG
5. RAISE end of FENCE, rotate guard COUNTER clock-
wise only enough to CLEAR fence.
6. LOWER fence and tighten both knobs.
H••• •
LIFT FENCE
: = :
i i iiii illl i • ,,i,,,,ll Hi
COUNTER
CLOCKWISE
WIDTH OF
il il II I Hill I IIIIIIIIIIIIIIIIIIIIII II I IIIII III II I IIII I IIII
........ ::: ::
: i :: ....
The normal position of guard (at REST) when fence js :
stationed at MAXIMUM WIDTH OF CUT_: issh0wn as
'position "A". NEVER ROTATE GUARD BE¥0NDI POSI_ ::
TION "B" BECAUSE THIS WOULD EXERT EXCESSIVE _
TENSION ON SPRING WHICH COULD WEAKEN OR_ .: POSITION "'A"
BREAK IT.
Check operation of GUARD and SPRING.
1. With fence in MAXIMUM WIDTH OF CUT position,
pass a piece of 1/4 in, thick wood on edge (jointing
position) over cutterhead.
2. The guard should return automatically to its REST
position against the fence when free of the wood.
3. If guard does not return to its REST position, remove
cotter pin from pivot pin and remove guard. Check
pivot pin and hole.., make sure there are no burrs,
rust, or other foreign matter. POSITION "B"
4. Apply afew drops of SAE No. 20 or No. 30 engine oil to
pivot pin.
:. 5.: Replace :guard and cotter pin. _i i _
_::::: i ;_ tfguard sti!l d°es not return to its REST position,conSult: :: i:: ::
:;::::::your: local: Sears Retail Store: before: using the: j0intet-:: ::: :: :: :