Craftsman 113.206891 Owner's Manual page 14

:to : yourjo" te lane
getting:: know:: mn r,p r
i
CROWNED CUT
5; _ ,.,EEO_=E" MUST,LWAYS BE P ARALLEL.TO
THE OUTFEED TABLE. .....
If the : cUt edge or surface of the workpiece is
CROWNED, it isan indication that the OUTWARD
END of the INFEED table is HIGH and must be
adjusted. :
tf the cut edge or surface of the workpeice is
CONCAVE, it is an indication that the OUTWARD
END of the INFEED table is LOW and must be
adjusted.
Check the infeed table to determine the "out of
parallel" condition.
i:I_ , I_<_--_-__ ' > _L_ __--_--'-I
: END HIGH
CONCAVE CUT
INFEED TABLE LOW
a. Insert a pencil in space at end of cutterhead to
hold cutterguard open,
b. Place a straightedge (large square or long level)
on outfeed table, First along oneside than along
the other,
c,,Raise infeed table until it touches straightedge,
d, Sight between table and straightedge to determine
high or tow condition of end of infeed table.
PENCIL
"
OUTFEED
TABLE
,111 ii iii ,,,,i, iiii :111 i iiiiiiiiiiiiiii
ROTATE
BLADE OUT OF
WAY
It is easier to adjust the infeed table whi ethe Jointe r :
is setting on your workbench.
Do not turn the Jointer on its side or upside down to
adjust it, : :: :
WARNING: Attach a strip of wood to two blocks of
wood 10 in. high. Drive enough nails into the strip so
that Jointer does not tip over while resting on blocks
causing possible injury.
a, Remove motor cord from outlet in switch box.
b. Remove Jointer pulley guard and V-belt.
c. Remove Jointer from stand.
10 IN.
!
d, Place Jointer on blocks.
• H : ¸¸•:• :• !: :;: • •_
14
BLOCKS
OF WOOD
YOUR WORK
BENCH