Installing Cutter Guard Spring - Craftsman 113.206891 Owner's Manual

10. Insert a blade in slot marked 1. ,, so it projects 1/16 in,
beyond end of the cutterhead.
11, "Insert a wedge next to blade so the flat side of the
wedge is against the blade. Push wedge in manualy
-do not install two locking setscrews at this time."
12. Place head of square on outfeed table, Loosen lifter
screws to raise blade _ntil it just touches square and
slightly raises it, Gently turn cutter head back and
forth with the pulley while raising blade. The blades
should be adjusted just slightly above the outfeed
table, by approximately ,003 in, (thickness of an
average piece of paper).
NOTE: Sears has a knife setting gauge for this purpose.
Cat. #9-2647
1/8 IN. SETSCREW WRENCH
HEAD OF
SQUARE
LIFTER SCREW
ii ,1111 iiii
13, "Now install both locking setscrews and tighten (with
the 5/32" setscrew wrench) alternately a little at a time.
Tighten both screws securely, Recheck the blade to
make sure it did not change position."
14. Install other two blades the same way.
INSTALLING CUTTER GUARD SPRING
1, Remove cotter pin from pivot pin in cutter guard and
remove guard (located underneath infeed table).
Spring must appear as in sketch from underside of infeed
table, it will not perform properly if installed upside down,
INFEED_.
/
I
\
f=PRING I
\ suPPORT/
sc"Lw- i
VIEW LOOKING UP
2!