Advertisement
OPERATION
(Cont.)
EDGE CHAMFERING
See Figure 7.
Your planer is designed with a groove in the front
shoe. The purpose of this groove is chamfering
edges. Before making a cut on good lumber, make a
few cuts on scrap lumber to determine the amount to
be removed from the board. Holding the depth ad-
justing knob with your left hand and the rear handle
with your right hand, place the groove on the surface
to be cut and move the tool slowly into the work.
Maintain downward pressure to keep your planer flat
at the beginning and the end of the work surface.
Fig, 7
MAINTENANCE
TIMING BELT REPLACEMENT
DISCONNECT
YOUR PLANER FROM POWER SUPP-
LY BEFORE CHANGING
TIMING BELT.
WHEN
REPLACING
TIMING
BELT, USE RECOM-
MENDED
REPLACEMENT
BELT ONLY. See Parts
List', Page 11.
1. Remove
the
two
(2)
belt
cover
screws.
Then
remove
the belt cover.
See
Figure
8.
2. Force old belt from small pugey with a screwdriver
and remove it from large pulley, If it is worn out,
simply cut the old belt and remove it.
3. Install new belt over large pulley first. See Figure
9.
4. Holding the belt as shownln
figu_ 9, p_ssthe
belt onto the smag pulley. NOTE: TO SIMPLIFY
THE PROCESS, TURN THE LARGE PULLEY AS
YOU
PRESS
THE
BELT
ONTO
THE
SMALL
PULLEY.
5. Reassemble belt cover and screws.
BELT COVER IS PART OF THE
DOUBLE INSULATED
SYSTEM.
NEVER
ATTEMPT
TO
OPERATE
YOUR
PLANER
WITHOUT
BELT
COVERIN
PLACE.
SMALL PULLEY
BELT COVER
LARGE PULLEY
TIMING BELT
POSITION HERE AND
TURN LARGE PULLEY
COVER
SCREWS
Fig, 8
LARGE PULLEY
Fig. 9
Page
7
Advertisement
