Sharpening Cutter Blades; Lubrication - Craftsman 113.206891 Owner's Manual

SHARPENII_G C UTTER BLADES
The blades can be honed individually with an ordinary
oilstone.
Make sure your oilstone is not worn in the center. It must
be flat.
Be sure to remove the burr on the flat side.
Ill I Illlll I I I II Illm 'l_'
if the blades are nicked, they must be replaced or
reground. They can be regrounded several times until
they become 9/t6 in. wide. Never install reground blades
less than 9/16 in. wide or unbalanced blades.
Have your knives reground by someone who is competent.
Look in the"Yellow Pages" of you r telephone directory...
see "Sharpening Services".
11116 IN.
NEW BLADE
i , ,,,,,,,,,,,,,,,,,,,, .........
general maintenance
Keep your jot nter-planer clean. Put a carton or some kind
of a container underneath your jointer-planer to catch the
chips. The container should reach above the top of the
motor.
Do not allow pitch to accumulate on the tables, the fence,
Do not allow chips to accumulate on the underside of the
jointer-planer.
Frequently blow out any dust that may accumulate inside
the motor.
If power cord is worn or cut, or damaged in any way, have
the cutter guard, the cutter head or the knives. Clean them
with Craftsman Gum and Pitch Remover.
Apply a thin coat of paste type wax to the tables and fence
so that the wood slides easily while feeding.
' ii iiiiiiipllll iii i iii ,111 i ii IIIImll!lllln
lubrication
it replaced immediately.
I II I I I L I L LLII lllllllll]llJll l
The BALL BEARINGS in this machine are packed with
grease at the factory. They requi re no further lubrication.
The following parts should be oiled occasionally with SAE
No. 20 or No. 30 engine oil.
1. Dovetail spacer and dovetail slide,
2, Elevating screw (first clean with Craftsman Gum and
Pitch Remover).
DOVETAIL
SPACER AND SLIDE
ELEVATING SCREW
VIEW LOOKING UP FOR
PARTS IDE NTI F ICATION
H
23